BHA 3" x1/32 x3/8" Cut-Off Wheels for Metal & Stainless - 25 Pack | Thin cut-off wheels slice steel, stainless & rebar fast and clean with minimal($19.65Value)

Description

STEEL, STAINLESS AND ALUMINUM: Use these metal cutting wheels on stainless steel, carbon steel, cast iron, aluminum and fiberglass. The 3-inch cutting disc format supports close-clearance cutting on compact workpieces where a larger wheel and guard cannot easily reach. THIN 1/32 INCH TYPE 1 BODY: A thin cutting wheel removes less material through the kerf and supports controlled cuts in small workpieces. A60 aluminum oxide uses a hard BF reinforced resinoid bond, with fiberglass reinforcement and a metal-reinforced arbor hole. DIE GRINDER CUTTING WHEEL: These die grinder discs are sized for air or electric cut-off tools using the correct 3/8-inch mandrel and guard. Cut only on the wheel edge. Never face-grind, sand, deburr or dress welds with this Type 1 cutting disc during use. PRECISION-BALANCED, RUNS TRUE: A balanced build keeps this 3" Type 1 die grinder cut-off wheel spinning true with minimal wobble, for accurate, controlled cuts in tight, close-clearance spots; sized for a 3/8" mandrel, rated to 25,000 RPM max. TRUSTED BY PROS: BHA (formerly Black Hawk Abrasives) is a name welders, fabricators, and metalworkers rely on - delivering consistent quality and dependable performance job after job, backed by real customer support. BHA (formerly Black Hawk Abrasives) is a professional-grade abrasive brand, built on Long Island, New York, since 2015. These grinder cut-off wheels are made for controlled cutting with compact die grinders and cut-off tools. Each 25-pack contains Type 1 flat wheels measuring 3" x 1/32" x 3/8". The 3-inch diameter suits compact die grinders plus air or electric cut-off tools, while the 3/8-inch arbor hole mounts on a compatible mandrel. No mandrel is included. Every die grinder cut-off wheel is rated to 25,000 RPM. The 1/32-inch body creates a narrow kerf. This thin profile removes less parent material and supports controlled cutting on compact workpieces. A60 aluminum oxide grain sits in a hard BF reinforced resinoid bond. Fiberglass reinforcement supports the wheel body, and a metal-reinforced arbor hole strengthens the mounting point. Use these 3-inch cut-off wheels for metal, stainless steel, carbon steel, cast iron, aluminum and fiberglass. A 3-inch cutting disc provides access around compact assemblies and close-clearance work where a larger cutting wheel cannot enter. These die grinder wheels are consumable cutting discs, not a cut-off tool or mandrel. A Type 1 wheel is flat and cuts only on its outer edge. Never use this metal cutting disc for face grinding, sanding, weld dressing, or deburring. Do not twist, bind or side-load the wheel. Use the correct guarded tool, verify the mandrel and flange fit the 3/8-inch arbor hole, and never exceed the marked speed. Inspect every cutting wheel before mounting and discard any wheel showing damage. Use the proper guard and personal protective equipment, follow the tool manufacturer's mounting instructions, and never overspeed. The label identifies ANSI B7.1 and EN 12413. This 25-pack keeps cut-off wheels ready for repeated shop, maintenance, and fabrication work.