BD Saw-Cut Loops SC 24-20 - Loop Size/Lead-in Size : 24 Foot Loop [4x8 or 6x6] / 20'($114.95Value)

Description

BD Loops Saw-Cut Loops - 18 to 52 ft loops - 20,50, or 100 ft lead-in Comes with 3/16" sealant tip Custom polyethylene outer jacket over nylon-coated poly insulated 16AWG stranded wire Built-in wing-shaped backer rod for snug fit in 3/16" wide groove 30% savings in loop sealant versus wrapped wires in 1/4" wide groove BD Loops saw-cut loops are available in 18-foot to 52-foot lengths with 20-foot, 50-foot or 100-foot lead-in wires. These saw-cut loops are designed for use in saw-cut installations where a 3/16-inch or larger groove is cut into the concrete or asphalt and the wire is stuffed and sealed (using loop sealant) into the surface. Each BD Loops saw-cut loop can save installers up to 55 minutes of installation time. Saw-cut loops have a custom durable polyethylene outer jacket over nylon-coated polyethylene insulated 16AWG stranded wire. The built in wing-shaped backer-rod allows the loop to fit snugly in a 3/16-inch saw-cut groove. The unique wire design prevents the installer from having to install backer-rod and creates a seal at the bottom of the groove, allowing the installer to apply sealant to a flat surface. This can result in up to 30 percent savings in loop sealant to seal the groove versus wrapped wires in a 1/4-inch wide groove. Every BD Loops saw-cut loop comes with a 3/16-inch sealant tip, which allows the installer to seal the loop in one pass from the bottom up. These loops work best with 3/16-inch wide saw-cut blades or 1/4-inch wide blades. Use a loop sealant, (not a crack filler) to seal the groove. The loop should be installed black side up (red side down) to ensure phasing direction matches down). Use a V-cut for the yoke to simplify your installation. Sprinkling sand over the sealant will create a barrier between the sealant and car ties and allow you to open the lane quicker.