AITRIP 4 PCS BTS7960 43A High Power Motor Driver Module/Smart Car Driver Module for Arduino Current Limit (4PACK)($21.99Value)

Description

5V isolate with MCU, and effectively protect MCU Isolated chip 5V power supply (can be shared with the MCU 5V), can also use the on-board 5V supply; BTS7960 The supply voltage is 5.5V to 27V Double BTS7960 large current H bridge driver, limit up to 43A large current output, with a strong drive and brake effects This driver uses Infineon chips BTS7960 composed of high-power drive full H-bridge driver module with thermal over-current protection

This driver uses chips BTS7960B composed of high-power drive full H-bridge driver module with thermal over-current protection

Double BTS7960 H-bridge driver circuit, with a strong drive and braking, effectively isolating the microcontroller and motor driver

Specification:

High-current 43A

Two heat flow passing through an error signal output

Supply voltage: 5.5V to 27V

5V power indicator on board

Just need four lines from MCU to driver module (GND. 5V. PWM1. PWM2)

Isolation chip 5 V power supply (can share with MCU 5V), can also use the on-board 5V supply

can solder heat sink

Control method: PWM or level

Duty cycle: 0-100%

PIN Definition:

RPWM: Right Turn PWM

 LPWM: Left Turn PWM

 R_EN: Right Turn Enable (High Active)

 L_EN: Left Turn Enable (High Active)

R_IS: Right Turn Current Warning (May Leave Floating)

 L_IS: Left Turn Current Warning (May Leave Floating)

 VCC: (5V)

 GND:signal common low end

Package Included:

4* BTS7960B H-bridge 43A High-Power Motor Driver Module