Cunyuer Timer Relay Module, AC100V-250V, Infinite Cycle Timer Delay On/Off Switch, Adjustable 0.5s 1000min, Automatic Operation, Silver Contact,($6.96Value)

Description

Practical: Can be used to control reciprocating travel, or for repeated power on and off testing of equipment and product aging ON/OFF: Supports start/stop function. After the module is powered on, it enters infinite loop mode, and the relay works according to the set running and stopping time Wide Time Range: Time range of 0.5s~1000min, you can set a wide time range, and both the run and stop times are adjustable Voltage: AC100V~250V, suitable for 100V/110V/120V/127V/220V/230V/240V power supply Usage: For specific usage of the product, please refer to the Product Description. It is suitable for timer operate equipment, machine repeated testing circuits, and fish tank intermittent pumps

Specifications:

Voltage: AC100V~250V

Power: <1.0W

Maximum Output Current: <10A

Input: Passive switch input, green led lights up after turn on, red led lights up after stop

Time Range: 0.5sec. to 1000min.

Time Accuracy: Maximum range value*0.001

Input(start button): Passive switch input, green led lights up after turn on, red led lights up after stop

Start input is not necessary. Connect these 2 terminals and then the board will cycle infinitely after power on.

Size: 88 x 38 x 22mm / 3.46 x 1.49 x 0.86"

Mounting Hole Spacing: 83 x 33mm / 3.26 x 1.3"

Mounting Hole Diameter: 3.2mm / 0.12"

Instruction:

Time can be set when the board is powered on or powered off.

1, Set Run Time:

Adjust the RUN TIME potentiometer clockwise to increase, counterclockwise to decrease.

The red switch below can set time range(left, 0-100 or 0-1000)

and unit(right, Sec. or Min.)

2. Set Stop Time:

Adjust the STOP TIME potentiometer clockwise to increase, counterclockwise to decrease.

The red switch below can set time range(left, 0-100 or 0-1000)

and unit(right, Sec. or Min.)

3. Start Button(Not included):

Connect a momentary push-button switch and press it, then green LED lights up indicating it is working. The board would automatically run according to the setting run time and stop time, infinite cycle.Press the start button again, then red LED lights up indicating it stops.

4. Time Setting Example:

Requirement: Run for 20 seconds, stop for 30 minutes, infinite cycle.

Settings:

(1)Set run time range to 0-100;

(2)Set run time unit to Sec.;

(3)Set run time potentiometer to 20 position, namely the position of 20/100 from left;

(4)Set stop time range to 0-100;

(5)Set stop time unit to Min.;

(6)Set stop time potentiometer to 30 position, namely the position of 30/100 from left;

Note:

1. Use a start button whose current is more than 0.1A

2. Please note that the new type and old type of this product will be sent randomly, and make sure you will not mind before ordering.

Package Includes:

1 x Timer Relay Module